This is an old revision of the document!
Table of Contents
Sand in iAVS
Sand is a crucial component of the Integrated Aqua-Vegeculture System (iAVS). It serves as both a growing medium for plants and a bio-filter for fish waste. In this section, we will discuss the ideal type of sand to use in an iAVS system and how to prepare it for use.
Ideal Filter Sand
The ideal filter sand for iAVS has a consistency approximately that of common table salt or of granulated sugar with no powdery fraction. Larger particles can easily be screened out, if necessary. This type of sand provides the best balance between water retention and drainage, which is essential for plant growth. It also allows for efficient filtration of fish waste, which helps maintain water quality.
Sourcing Sand
It is usually relatively easy to find a source of an appropriate grade of sand. However, it is important to choose a source that is free from contaminants such as silt or clay.
Preparing Sand
Before using sand in an iAVS system, it must be thoroughly washed and sterilized to remove any impurities or pathogens. To do this, follow these steps:
1. Rinse the sand thoroughly with water to remove any loose debris. 2. Fill a large container with water and add the sand. 3. Stir the sand vigorously to loosen any dirt or debris. 4. Drain off the dirty water and repeat steps 2-3 until the water runs clear. 5. Sterilize the sand by soaking it in boiling water for at least 30 minutes. 6. Drain off the hot water and rinse the sand with cool water.
Once the sand has been washed and sterilized, it is ready to be used in an iAVS system. By following these steps, you can ensure that your sand is free from contaminants and will provide the best possible growing conditions for your plants.
Maintaining Sand
Maintaining the sand in an iAVS system is crucial for the health of both the plants and fish. Over time, the sand can become compacted or clogged with debris, which can impede water flow and reduce filtration efficiency. To prevent this from happening, it is important to regularly monitor and maintain the sand in your iAVS system.
One way to maintain the sand is to periodically stir it up with a rake or small hoe. This will help loosen any compacted areas and prevent debris from accumulating on top of the sand.